One thing’s for sure– herbalists go through a lot of bottles! For a profession where environmental impact rates high on the list of our concerns, the last thing we want to do is add to a bunch of bottles, caps, and droppers to the mountainous landfills. We clean and reuse bottles at Herbalista and wanted to share with you the methods we have found safe and efficient.
When a bottle is returned to us, we pour out any leftover tincture, oil, etc and then place the bottles into a very hot, soapy bath. Leaving them to soak for a time allows the labels and any residue to loosen. The labels will practically fall off, and for the more stubborn parts, simply use the label bits that did come free and rub that over the remaining adhered label. That will usually work it free. If parts still don’t come free try a wee bit of olive oil or alcohol.
We have a number of different sized bottle brushes with which we can scrub the inside of each bottle. When scrubbed and rinsed, they are placed on the bottle wrack for drying. When dry we hold them to the light to check for any obvious organic material or residue that may remain. If we see any, we put it through the same initial soak and scrub all over again. If it appears clean we place the bottle into a box for Phase II.
DROPPERS & CAPS
We completely dissemble the droppers– separating the pipettes, the squeeze bulbs, and the plastic rings from one another. We also separate the internal plastic phenolic cone from the caps with the use of a pointed set of tweezers. These bits and pieces are all then immersed in a soapy, hot bath for a soak. We use either a mascara wand (purchased from a beauty supply store) or pipe cleaners to clean the inside of the pipettes, squeeze bulbs, and other hard to reach places. After this prewash we pack everything into a bin for Phase II.
In order to feel like the bottles and tops have received a complete wash and sanitation for reuse, we use a dishwasher and program it for with the highest heat setting. Since Lorna is not gifted with a dishwasher Herbalista HQ, the next step involves schlepping all the bottles and various accoutrement to her mother’s house (is there ever a time we stop needing assistance from our folks) to run them through her machine. We use a simple eco-friendly detergent with the above mentioned settings. After they have been run through, we schlep them back to HQ for the final stages of this “ever-so-time-consuming-but-totally-worth-it” cleaning protocol.
The bottles are lined up against the west facing window bank to allow for any last bits of moisture to escape. When the bottles appear completely dry (usually in a matter of hours) they are placed into the bottle cabinet.
The tops are laid out on a clean towel on the table. The blue bottle in the picture here is filled with 70% alcohol. We spritz them all over and wipe them down with a thin cotton towel. This is a chance to have your eyes on everything and do some good quality control. Finally, all is reassembled to be used once more to dole out sweet, sweet herbal medicine
For any bottle or top that doesn’t pass muster (using organoleptic evaluations of sight and smell) they are put back into the bin for another round of cleaning or put into the recycling bin. You will find that over time, the squeeze bulbs loose their integrity (notice in the photograph that some are starting to look a bit grey) and they will eventually get pulled. This is a bit frustrating, because the pipettes and ring are still completely fine. We have searched and have yet to find a distributer of just the bulbs. So we’ve taken to keeping the extra pipettes in a cup for tastings of herbal concoctions, which feels like a fine way for them to spend their retirement!
updated on 04.21.17